With advances in micromachinery, the aggregation of sensors, and more powerful microcontroller platforms on satellites, the size of avionics for space missions are getting dramatically smaller with faster processing speeds. This has resulted in greater localized heat generation, requiring more reliable thermal management systems to enhance the thermal performance of the avionics. The emergence of advanced additive manufacturing (AM), such as selective laser melting (SLM) and engineering materials, such as low-melting eutectic liquid metal (LM) alloys and synthetics ceramics offer new opportunities for thermal cooling systems. Therefore, there has been an opportunity for adapting in-situ AM to overcome limitations of traditional manufacturing in thermal application, where improvements can be achieved through reducing thermal contract resistance of multi-layer interfaces. This dissertation investigates adapting in-situ AM technologies to embed LM compatible prefabricated components, such as ceramic tubes, inside of metals without the need for a parting surface, resulting in more intimate contact between the metal and ceramic and a reduction in the interfacial thermal resistance. A focus was placed on using more ubiquitous powder bed AM technologies, where it was determined that the morphology of the prefabricated LM compatible ceramic tubes had to be optimized to prevent collision with the apparatus of powder bed based AM. Furthermore, to enhance the wettability of the ceramic tubes during laser fusion, the surfaces were electroplated, resulting in a 1.72X improvement in heat transfer compared to cold plates packaged by conventional assembly. Additionally, multiple AM technologies synergistically complement with cross platform tools such as magnetohydrodynamic (MHD) to solve the corrosion problem in the use of low melting eutectic alloy in geometrically complex patterns as an active cooling system with no moving parts. The MHD pumping system was designed using FEA and CFD simulations to approximate Maxwell and Navier-Stokes equations, were then validated using experiments with model heat exchanger to determine the tradeoff in performance with conventional pumping systems. The MHD cooling prototype was shown to reach volumetric flow rates of up to 650 mm3/sec and generated flow pressure due to Lorentz forces of up to 230 Pa, resulting in heat transfer improvement relative to passive prototype of 1.054.
|Commitee:||Dasgupta, Abhijit, Bigio, David, Choi, Kyu Yong, Sochol, Ryan|
|School:||University of Maryland, College Park|
|School Location:||United States -- Maryland|
|Source:||DAI-B 82/8(E), Dissertation Abstracts International|
|Subjects:||Mechanical engineering, Electrical engineering, Materials science, Thermodynamics, Systems science|
|Keywords:||Additive manufacturing, Assembly systems, Contact resistance, Liquid metal, Magnetohydrodynamic, Optimality|
Copyright in each Dissertation and Thesis is retained by the author. All Rights Reserved
The supplemental file or files you are about to download were provided to ProQuest by the author as part of a
dissertation or thesis. The supplemental files are provided "AS IS" without warranty. ProQuest is not responsible for the
content, format or impact on the supplemental file(s) on our system. in some cases, the file type may be unknown or
may be a .exe file. We recommend caution as you open such files.
Copyright of the original materials contained in the supplemental file is retained by the author and your access to the
supplemental files is subject to the ProQuest Terms and Conditions of use.
Depending on the size of the file(s) you are downloading, the system may take some time to download them. Please be