The current project presents the test development and implementation of an in-house designed Electronic Control Unit (ECU) for automotive applications. Electronic components such as switches, lights, motors, sensors, etc. throughout the vehicle uses Controller Area Network (CAN) Bus to communicate on single or dual-wire network. Four Door Control Module (DCM) ECU will preside in the vehicle: front right, front left, back right, and back left. To emulate and test the ECU features, a test board is designed to test on and off board passive electrical components using the National Instruments Compact Data Acquisition (NI C-DAQ) hardware and the Laboratory Virtual Instrument Engineering Workshop (LabView) software platform. Experimental results were gathered using the test equipment and LabVIEW to validate the correct operations of the DCM ECU inputs and outputs in a controlled environment. After the hardware has been validated under test conditions, it’s ready to be tested under field conditions.
|Commitee:||Khoo, I-Hung, Mozumdar, Mohammad|
|School:||California State University, Long Beach|
|School Location:||United States -- California|
|Source:||MAI 57/06M(E), Masters Abstracts International|
Copyright in each Dissertation and Thesis is retained by the author. All Rights Reserved
The supplemental file or files you are about to download were provided to ProQuest by the author as part of a
dissertation or thesis. The supplemental files are provided "AS IS" without warranty. ProQuest is not responsible for the
content, format or impact on the supplemental file(s) on our system. in some cases, the file type may be unknown or
may be a .exe file. We recommend caution as you open such files.
Copyright of the original materials contained in the supplemental file is retained by the author and your access to the
supplemental files is subject to the ProQuest Terms and Conditions of use.
Depending on the size of the file(s) you are downloading, the system may take some time to download them. Please be