Between two neighboring air bubbles in a froth (or foam), a thin liquid film (TLF) is formed. As the bubbles rise upwards, the TLFs thin initially due to the capillary pressure (pc) created by curvature changes. As the film thicknesses (H) reach approximately 200 nm, the disjoining pressure (Π) created by surface forces in the films also begins to control the film drainage rate and affect the waves motions at the air/water interfaces. If Π < 0, both the film drainage and the capillary wave motion accelerate. When the TLF thins to a critical film thickness (Hcr), the amplitude of the wave motion grows suddenly and the two air/water interfaces touch each other, causing the TLF to rupture and bubbles to coalesce.
In the present work, a new model that can predict H cr has been developed by considering the film drainage due to both viscous film thinning and capillary wave motion. Based on the H cr model, bubble-coarsening in a dynamic foam has been predicted by deriving the geometric relation between the thickness of the lamella film, which controls bubble-coalescence rate, and the Plateau border area, which controls liquid drainage rate.
Furthermore, a model for predicting bubble-coarsening in froth (3-phase foam) has been developed by developing a film drainage model quantifying the effect of particles on pc. The parameter pc is affected by the number of particles and the local capillary pressure ( pc,local) around particles, which in turn vary with the hydrophobicity and size of the particles in the film. Assuming that films rupture at free films, the pc corrected for the particles in lamella films has been used to determine the critical rupture time (t cr), at which the film thickness reaches Hcr, using the Reynolds equation. Assuming that the number of bubbles decrease exponentially with froth height, and knowing that bubbles coalesce when film drains to a thickness Hcr, a bubble coarsening model has been developed. The model predictions are in agreement with the experimental data obtained using particle of varying hydrophobicity and size.
|Commitee:||Adel, Gregory T., Jung, Sunghwan, Luttrell, Gerald H., Ragab, Saad A.|
|School:||Virginia Polytechnic Institute and State University|
|Department:||Mining and Minerals Engineering|
|School Location:||United States -- Virginia|
|Source:||DAI-B 79/04(E), Dissertation Abstracts International|
|Subjects:||Mechanical engineering, Mining|
Copyright in each Dissertation and Thesis is retained by the author. All Rights Reserved
The supplemental file or files you are about to download were provided to ProQuest by the author as part of a
dissertation or thesis. The supplemental files are provided "AS IS" without warranty. ProQuest is not responsible for the
content, format or impact on the supplemental file(s) on our system. in some cases, the file type may be unknown or
may be a .exe file. We recommend caution as you open such files.
Copyright of the original materials contained in the supplemental file is retained by the author and your access to the
supplemental files is subject to the ProQuest Terms and Conditions of use.
Depending on the size of the file(s) you are downloading, the system may take some time to download them. Please be