Dissertation/Thesis Abstract

Model and design of distributed embedded systems
by Dasamoni, Thanga Nirmala, M.S., California State University, Fullerton, 2016, 71; 10245103
Abstract (Summary)

Many model-based approaches have been suggested to improve and accelerate the development process of complex distributed embedded systems (DES) from design to deployment. In this approach, abstract models of the system are created and then transformed systematically into concrete implementations. Modeling focuses on commands and information being distributed reliably throughout the system with minimized latency to maintain acceptable QoS. In this research, an irrigation system is developed. Model-based development was used to model the architecture and communication of distributed nodes. However, the complexity of the Bluetooth Low Energy (BLE) communications used by the irrigation system requires a model with very high sophistication in the bottom-up modeling approach. A distributed irrigation system is implemented as a proof of concept using an experimental Bluetooth Low Energy based network topology and protocol, and the data was observed to verify the correct operations.

Indexing (document details)
Advisor: Turi, Michael
Commitee: Faller, Kenneth John, George, Kiran
School: California State University, Fullerton
Department: Computer Engineering
School Location: United States -- California
Source: MAI 56/03M(E), Masters Abstracts International
Source Type: DISSERTATION
Subjects: Computer Engineering
Keywords: Bluetooth low energy, Distributed embedded sytems, Irrigation controller
Publication Number: 10245103
ISBN: 9781369544138
Copyright © 2019 ProQuest LLC. All rights reserved. Terms and Conditions Privacy Policy Cookie Policy
ProQuest