Higher alcohol synthesis (HAS) from syngas or biomass-derived syngas is an important process for the production of oxygenate fuels, fuel additives and other intermediates for value-added chemical feedstock to produce medicine, cosmetics, lubricants, detergents, and polyesters.
Chapter I reviews biomass to liquid fuels technology, higher alcohols being used as alternative fuels and fuel additives, the historical perspective and commercial status of higher alcohols, the catalyst system and the reaction mechanism for HAS from syngas.
Chapter II discusses the Zn-Mn promoted Cu-Fe based catalyst that was synthesized by the co-precipitation method. The reaction temperature has been tested to study the influence on the catalytic performance. The maximal CO conversion rate was 72%, and the yield of alcohol and hydrocarbon was also very high. Cu was the active site for alcohol synthesis, iron carbide was the active site for olefin and paraffin synthesis. The reaction mechanism of HAS from syngas over Zn-Mn promoted Cu-Fe based catalyst was proposed.
Chapter III documents the three-dimensionally ordered macroporous (3DOM) Cu-Fe catalyst developed using a glyoxylate route colloidal crystal template method. The high intrinsic activity was ascribed to three factors. First, the unique ordered structure has a large pore size and interconnected macroporous tunnels of the catalyst with a large accessible surface area to improve the catalytic activity. Second, a high density of uniformly distributed defective Cu0 and Fe5C2 nanoparticles derived from the glyoxylate route helps to provide abundant, active, and stable dual sites. Third, atomic steps on the Cu surface, induced by planar defects and lattice strain, serve as high-activity oxygenation sites. Active Fe5C 2 chain-growth sites intimately surround the defective and strained form of the Cu surface, which results in a synergetic effect between the active and stable Cu–FexCy dual site for HAS.
In Chapter IV, in situ ambient pressure x-ray photoelectron spectroscopy and in situ synchrotron powder diffraction were applied to identify the active site of 3DOM Cu-Fe catalyst for HAS. The results show that after syngas pretreatment of the 3DOM Cu-Fe catalyst, Cu0 is the active oxygenation site for alcohol synthesis, and Fe5C2 is the active site for carbon chain growth.
|Commitee:||DuBien, Janice, Mlsna, Todd E., Schneider, Judith A., Srinivasan, Radhakrishnan|
|School:||Mississippi State University|
|Department:||Agricultural and Biological Engineering|
|School Location:||United States -- Mississippi|
|Source:||DAI-B 76/04(E), Dissertation Abstracts International|
|Subjects:||Engineering, Energy, Materials science|
|Keywords:||Copper-iron catalyst, Higher alcohol synthesis, In situ ap-xps, In situ synchrotron powder diffraction, Structure-activity relationship, Syngas|
Copyright in each Dissertation and Thesis is retained by the author. All Rights Reserved
The supplemental file or files you are about to download were provided to ProQuest by the author as part of a
dissertation or thesis. The supplemental files are provided "AS IS" without warranty. ProQuest is not responsible for the
content, format or impact on the supplemental file(s) on our system. in some cases, the file type may be unknown or
may be a .exe file. We recommend caution as you open such files.
Copyright of the original materials contained in the supplemental file is retained by the author and your access to the
supplemental files is subject to the ProQuest Terms and Conditions of use.
Depending on the size of the file(s) you are downloading, the system may take some time to download them. Please be